Eagle Home Products Eagle Series User Manual download pdf (Page 80)

74 • Appendix I: Installing the Data Logger Board Eagle Instruction Manual

Appendix I: Installing the Data Logger Board

Appendix H describes the procedure to install the Eagle’s data logger

board. The data logging feature is an optional accessory.

NOTE: Although the data logger board may be installed in the ﬁeld,

RKI Instruments, Inc., recommends that you return the Eagle

to the factory for data logger board installation.

1. Take the Eagle to a non-hazardous location, and turn the power

off.

2. Unscrew the two large screws on the top of the case., then

carefully lift the top of the case and lay it aside.

3. Unplug the ribbon cable from the main circuit board in the top

case.

4. Remove the two screws, ﬂat washers, and lock washers that hold

the main circuit board in the top case.

5. Slowly pull the main circuit board from the top case far enough to

allow room to install the Data Logger board. Avoid pulling so far

that you disconnect any of the four cables on the main circuit

board.

6. Plug the Data Logger board into the main circuit board at CN1A,

CN1B, CN1C, and CN1D.

7. Reassemble the main circuit board to the top case with the screws

and lock washers removed in step 4.

8. Plug in the ribbon cable.

9. Reassemble and secure the top case to the bottom case.

10. Start the Eagle and program the Data Logger functions as

described in “Setup Mode” on page 23.

1 2 ... 75 76 77 78 79 80

No comments

Eagle Home Products Eagle Series User Manual Page 80