Eagle Home Products Eagle Series User Manual download pdf (Page 30)

24 • Setup Mode Eagle Instruction Manual

• To exit setup mode, from the main menu place the prompt next to

the last menu option, START MEASUREMENT, then press the

POWER/ENTER button. The Eagle begins its normal start-up

sequence.

Entering Setup Mode

WARNING: The Eagle does not detect gas or display readings while

in setup mode. The CAL/SETUP switch (SW2) must be in

the ON position to enter setup mode.

1. Take the Eagle to a non-hazardous location, and turn the power

off.

2. Press and hold down the AIR/▲ and SHIFT/▼ buttons, then

press the POWER/ENTER button. The main menu displays. It

displays four menu options at a time. Press the AIR/▲ or SHIFT/

▼ button to view additional menu options.

Updating the Battery Type Setting

This setting allows you to select between alkaline and Ni-Cd batteries.

The Eagle uses this setting to make sure adequate time is given

between the low battery warning and low battery alarm. This setting

has no effect on battery charging.

1. From the main menu, select the BATTERY TYPE menu option.

2. Press the AIR/▲ or SHIFT/▼ button to display the desired

setting.

CAUTION:This setting should always match the type of batteries (alkaline

or Ni-Cd) installed in the Eagle. If this setting does not match

the installed batteries, the time between low battery warning

and low battery alarm may be less than expected.

3. Press the POWER/ENTER button to enter the setting and return

to the main menu.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 79 80

No comments

Eagle Home Products Eagle Series User Manual Page 30